DANGER RESTRICTED AREA

DANGER SIGNS are used where an immediate hazard situation exists and if not avoided, will result in DEATH or SERIOUS INJURY. Danger wording should not be considered for property damage accidents unless personal injury risk is present. All employees shall be instructed that DANGER SIGNS indicate immediate danger and that special precautions are necessary. OSHA 1910.145(c)(1)(ii). The sign should contain sufficient information to be easily understood. OSHA 1910.145(e)(2). Signs are .063 aluminum and reflective.

DANGER TAPE 1000'

DANGER TAPE 300'

DANGER TAPE, 3" X 1000' RED

DAY 1 FINISHING AID - RTU

DAY1® Finishing Aid Brickform DAY1 is a colloidal silica-based finishing aid that makes concrete flatwork finishing easier and faster. It produces a better result and reduces the risk of a prematurely setting slab. Applied during floating and troweling, DAY1 finishing aid increases cream and extends workability under adverse conditions such as high wind, heat, or low humidity. It eliminates the need to add water to the surface which can lead to premature surface failure. DAY1 does not alter the water-to-cement ratio and becomes a permanent part of the slab so there is no membrane or residue to remove.

DAYTON B-14 "L" COIL BOLTS (VARIOUS SIZES)

•B14 coil bolts have fast-acting, self-cleaning threads and are available in 3/4”, 1”, 1-1/4” and 1-1/2” diameter bolts. •B14 coil bolts have fast-acting, self-cleaning threads and are available in 3/4”, 1”, 1-1/4” and 1-1/2” diameter bolts. •Bolts may be furnished with integrally formed heads or made with B12 coil rod and B25 hex nuts securely welded on. •May be reused—but will wear and must be regularly inspected. •Must be kept clean and lubricated.

DAYTON B-16 3/4 X 6" STRAIGHT COIL LOOP INSERT

Although simple in design and fabrication, the B16 Straight Coil Loop Insert is highly efficient for lifting and handling precast concrete elements. Standard inserts are shown in the chart. Special inserts for use with larger diameter coil bolts, or with loops having longer lengths and of heavier wire can be furnished, if required, on special order

DAYTON B-18 3/4" X 6" FLARED COIL LOOP INSERT

The load carrying capacity of any cast-in-place concrete insert is largely dependent upon the ability of the insert to draw upon the tensile strength of the mass of concrete within which it is embedded. The B18 Single Flared Coil Loop Insert makes effective use of this principle by increasing the depth and width of concrete embedment. B18 inserts are available with an optional B3 Screw-on Coil for use with the B30 Screw-on Plastic Cone which acts to set the insert back from the face of the concrete. Minimum spacing between inserts is twice the corner distance.

DAYTON BAR

The A95 - Dayton Bar is manufactured with a 1” x 2” structural tube handle that has been carefully Mig welded to a heat-treated milled blade. This bar is an ideal tool for use by the tilt-up erector— you will find many uses for it, from adjusting and/or stripping side forms to “jockeying” tilt-up wall panels into position. Available with either a 3” or 5” wide blade. Please specify blade width when ordering.