TRUPER SCRAPERS

TU 1-1/2" TO 4" GTI SUPER CHAIR

GTI® provides the strongest Composite PC Chairs available in the market. They are made from composite material and exceed the strength of comparable wire supports by up to ten times. The product size is identified on the top of the product. GTI® composite material offers continuous corrosion protection, both on the job-site and in concrete providing a great alternative to epoxy, stainless, and galvanized bar supports. The GTI® line of Composite PC Chairs contains rounded balls on the bottom of the feet so as not to damage formwork and remain invisible when concrete is exposed. GTI Composite PC Chairs are grey in color (custom colors are available) to blend in with concrete and show virtually no change in strength in temperatures ranging from 0°F to 300°F. Primary Uses: Precast Concrete Slabs and Wall Panels Single Mat Support - Post-Tensioning, Rebar, or Mesh Top Layer Double Mat Support - Post-Tensioning, Rebar, or Mesh Tilt-Up Concrete Wall Panels Slab-on-Ground using a Sand Plate Elevated Slabs

TUB-O TOWELS

90 TOWEL CANISTER

TUB-O TOWELS (90 TOWELS PER CANISTER)

They're bigger, tougher and soaked with a knock-your-socks-off cleaning solution that overpowers even the most onerous grime. Just reach for Tub O' Towels and show challenging cleaning jobs that you mean business. Unlike typical wimpy wipes, our thick towels hold up to vigorous scrubbing. Use them inside, outside, on the job, or on the go.

TUB-O TOWELS SINGLE PACK

100 PER TUB

TUBE SAND 60LB

56/PLT

TWINMAX-32 14" DIAMOND CHAIN

TYPE 1 GEOGRID 12.5' X 328' (ODOT APPROVED)

All geometric properties are Nominal Values and may vary. All mechanical properties are based on the manufacturer’s laboratory test results at 21¬±1 C. Unless indicated otherwise, values shown are minimum average roll values determinate in accordance with ASTM D4759. Expressed as a comparison of ASTM D7737 strength to ASTM D6637 strength of the same sample. ASTM D7737 performed at 10% per minute strain rate. Using specimens 2 ribs wide with ribs transverse to the specimen cut flush with the exterior edges of the ribs in the direction of the specimen. Resistance to in-plane rotational moment of 20 kg-cm. 500 hour exposure. 120 day immersion testing. Expressed as a percentage of Ultimate Tensile Strength

TYPE 2 GEOGRID 12.5' X 328' (ODOT APPROVED)

All geometric properties are Nominal Values and may vary. All mechanical properties are based on the manufacturer’s laboratory test results at 21¬±1 C. Unless indicated otherwise, values shown are minimum average roll values determinate in accordance with ASTM D4759. Expressed as a comparison of ASTM D7737 strength to ASTM D6637 strength of the same sample. ASTM D7737 performed at 10% per minute strain rate. Using specimens 2 ribs wide with ribs transverse to the specimen cut flush with the exterior edges of the ribs in the direction of the specimen. Resistance to in-plane rotational moment of 20 kg-cm. 500 hour exposure. 120 day immersion testing. Expressed as a percentage of Ultimate Tensile Strength